No articles found for “”.
Test mode vs live mode
Every SpireSlip entity is either in test mode or live mode. The mode controls what happens when you disburse a payroll, and it's the single most important thing to understand before paying real salaries through SpireSlip.
How the mode is set
The mode is decided by the disbursement key you save on the entity. SpireSlip reads the key's prefix:
- Paystack: SpireSlip detects test vs live mode from your key prefix: keys beginning with
sk_test_are test mode,sk_live_are live mode.
For Paystack, you don't pick the mode separately: it's inferred from the key you paste in.
Where you can see the current mode
Go to Entities, open the entity, then click the Payroll tab. The Disbursement section shows a banner:
- Amber banner. Test mode. Transfers will not move real money.
- Green banner. Live mode. Transfers will move real money on disbursement.
What happens to transfers in each mode
In test mode, payroll runs compute and approve the same way they do in live mode, and disbursement goes through the same Paystack API. But no real money moves, the test recipient codes are rejected by the live transfer engine, so transfers show as failed. This is exactly what you want during setup: you can practise the whole flow without a single naira leaving your account.
In live mode, an approved disbursement initiates real bank transfers. Money leaves your Paystack balance and lands in your employees' accounts. There is no undo.
When to switch
Set up your entity, add a few employees, run a practice payroll, and verify everything looks right, all in test mode. When you're confident the setup is correct, switch to live mode before your first real payroll run.
Next: read Configuring disbursement to add your provider keys, then Switching to live mode for the pre-flight checklist.