Skip to main content
SpireSlip

Enrolling a kiosk device

A device becomes a kiosk once an owner or admin enrols it. Only enrolled devices can record taps.

Enrol a device

  1. Go to Attendance > Office kiosk, type a name for the device under Kiosk devices (for example "Ikeja reception tablet") and click Get enrolment code.
  2. An 8-character code is shown once. It is valid for 15 minutes and works once.
  3. On the office device, scan the QR code shown next to the code with the device's camera, or open the link shown there (use Copy link to send it, for example on WhatsApp, to whoever is holding the device). The enrolment page opens with the code already filled in; tap Enrol device. Typing the address and the code by hand also works.
  4. The device must be on a network in your office IP list. A code typed from anywhere else is refused, so a code read over the phone cannot enrol a device at home.

Once enrolled, the device keeps a private key in its browser. Nobody can see or copy it from SpireSlip. Leave the kiosk page open; it refreshes itself when idle. If the browser's data is cleared, enrol the device again.

Revoke a device

Click Revoke next to the device. The next tap from it is refused and the device shows "This device is no longer enrolled". Revoke a device straight away if it is lost or stolen. A stolen device shows no employee data, and it only works on your office network.

Replacing a device

Enrol the new device with a new code, then revoke the old one. Each device has its own entry, last-seen time and last network address, so you can tell them apart.