Skip to main content
SpireSlip

Biometric login

SpireSlip can use your device's fingerprint or Face ID for sensitive actions instead of asking you to retype your password. This is faster, harder to phish, and works even on devices where you have a password manager that already fills in your sign-in form.

What it covers

Biometric login is a SECOND factor, not a replacement for your password. You still sign in with email and password the first time. After that, certain actions ask you for a fresh biometric check when you have been idle:

  • Approving a payroll run
  • Disbursing salaries
  • Any page inside the SpireSlip admin area

Sending salaries and changing an employee's bank details also ask you to confirm it is you, with your password or your authenticator code. A biometric check does not replace that step. See Account security.

Other actions (viewing reports, editing employees, sending contracts) continue to use the regular session timeout.

Setting it up

  1. Sign in to SpireSlip on the device you want to use.
  2. Open Settings and switch to the Security tab.
  3. Find the Biometric login section and tap Set up fingerprint or Face ID.
  4. Approve the browser's prompt with your fingerprint, Face ID, or device PIN.
  5. Give the device a name (for example, "iPhone" or "work laptop") so you can identify it later.

You can register more than one device. Each device is a separate entry in the Security tab.

When the prompt appears

When you try to approve or disburse payroll (or open an admin page) after about thirty minutes of inactivity, SpireSlip pauses the action and shows a small biometric confirmation page. Approve the prompt and SpireSlip continues with your original action automatically. You do not have to redo the form.

If your browser does not support it

Biometric login uses a web standard called WebAuthn. Modern Chrome, Edge, Safari, and Firefox on phones and laptops support it. If your browser does not, the biometric section in Settings is hidden, and you will be asked for your password instead during the sensitive-action check.

Replacing or removing a device

Each registered device is shown as its own entry under Biometric login. To remove one, tap Remove next to it. For your safety we ask you to confirm with a fresh biometric check (or your password, if biometric is not available) before removing a device. This stops a one-time stolen session from quietly disabling your second factor.

If you replace your phone, remove the old entry from the Settings page on the new device, then set up biometric login on the new device.

If something is not working

  • If the prompt does not appear, check that your browser allows biometric prompts on SpireSlip and that your device has at least one fingerprint or Face ID enrolled.
  • If you see "verification failed" after a successful prompt, your authenticator may have been used elsewhere. Remove the device entry and set it up again.
  • If you lose access to all your registered devices, sign in with your password as usual. You will keep getting password prompts for the sensitive actions, but you will not be locked out.